Soldering and Coating a CEA Strain Gage (Training Video)

The recommended procedures and materials needed for attaching leadwires to a Micro-Measurements CEA strain gage and applying a coating to the gage to protect it in the laboratory environment are covered in this video. Although soldering is basically a simple procedure, the experience-proven methods featured in this video result in reliable strain gage installations based on the use of Micro-Measurements gages and installation accessories

Available Videos

ALT
StrainSmart® Data Systems Overview (Product Info)

This video provides a comprehensive product overview of the Micro-Measurements System 5000, 6000, and 7000 data acquisition systems with our StrainSmart® Software.

ALT
M-Bond 610 Adhesive Used on WK-Series Strain Gage (Training Video)

This training video covers the steps involved in bonding a WK-Series strain gage using M-Bond 610 Adhesive.

ALT
Soldering and Coating a CEA Strain Gage (Training Video)

This training video covers the steps involved in properly soldering lead wires to a CEA strain gage and applying a protective coating to the gage.

ALT
CEA Strain Gage Installation with M-Bond 200 Adhesive (Training Video)

This training video covers the installation of a CEA Strain Gage with M-Bond 200 Adhesive.

ALT
Strain Gage Surface Preparation for Steel and Aluminum Alloys (Training Video)

This training video covers surface preparation for strain gage installation on steel or aluminum alloys

ALT
Technical Training Programs (Introductory Video)

This video provides an overview of the technical training programs offered by Micro-Measurements.

ALT
System 8000 (Product Info)

This video provides an overview of Micro-Measurements’ System 8000 StrainSmart® Data Acquisition System.

ALT
Validation of the Aerodynamic Downforce of a Race Car

In this video, a strain gage is used to measure aerodynamic downforce in a race car. The video illustrates how the overall balance and performance of the car’s suspension system is improved by an enhanced airflow design based on measurements from Micro-Measurements strain gages.

ALT
Single-channel strain sensor data acquisition: StudentDAQ

This video introduces the single-channel strain sensor data acquisition tool for students. This Data Acquisition Systems is designed for use in applications where a convenient, low-cost, easy-to-use strain gage measurement is required.

ALT
RS-200

This video provides a brief introduction to residual stress measurement using the hole drilling method, including the RS-200 milling guide.